Separate names with a comma.
I'd just let it fill in, it should eventually
It looks like you have a hotspot where the lights are located. If you can, back them away from the scrubber a bit. If you can't, you can try a...
yes, that's similar to what I was talking about, and not a big concern. I would not worry about that, that type of growth should rinse away...
Normally yes, but also a blank screen takes 4-6 weeks to reach maturity, and that's in an established tank. This goes back to intensity and...
Back the scrubber way off - you can't hit a blank screen on a tank with no bioload with a long photoperiod at a high level of intensity or you...
Oops sorry man I missed this post. For violets, look for "hyper violet" which is typically 410-420 nm
If you're getting GHA with some slime forming a sort of "coating" over the GHA, that is a phase that sometimes occurs. Not really sure why, but...
treat like a new screen, limited photoperiod until you have growth that can absorb that amount of light clean as many as 2-3 times/week for...
it doesn't look like there's much white encrustation, it would look like a solid (opaque) white coating. I'd say you're just starting over rinse...
hard to tell. look for the white encrustation, that's not a good surface for re-growth
If you cook it hard, and the screen ends up with a white crust on it, you have to vinegar-soak that screen and scrub everything off and start...
Add either, I think the benefit is about the same. I wire up the violets in parallel with each other, then put that parallel pair in series with...
the ultra stiff, IMO, is no better. It's more difficult to rough up, I like the regular stuff If you want to
yes
Sorry, busy week - shifted over my efforts to making face shields Thanks @Pny for chiming in
You can always do a partial harvest to trim back heavier growth. Remember to always rinse under running water while rubbing with fingertips...
I'm not familiar with that one
ATS = Algal Turf Scrubber = Algae Scrubber :)
Nice! Just for anyone else reading this, something like this only really works when you have specific LED arrays. So you can't take any...
It looks like you could set the scrubber on the center crossing point of the sump, with the drain going down into the 2nd chamber (front/left) and...
